Hello, I rolled my tractor and bent one of the hydraulic lift arms. Has anyone replaced one on a 2650? I can’t seem to find any replacement arms for this particular model or any instructions on how to replace the arm itself? Any suggestions would be appreciated. Thanks!
Replacing a hydraulic control arm on B2650
- Thread starter Jasonc
- Start date
Donystoy
Active member
Lifetime Member
Equipment
LX2610HSDCC, B/H, Loader, plus numerous other attachments. B7200 sold
If this is the 3 point lift arms you should be able to straighten them using a hydraulic press. Do you have a picture of the damage?
That would be very helpful, Jason. That way we know for sure what you are talking about and the extent and nature of the damage.
I hope nobody was hurt in the rollover! You're able to post here, so that's good, at least!
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
This is assuming that your talking about the lower arm on the three point.
Fortunately I was able to jump off and the tractor just flopped over.
I didn't have a chance to take a pic but the part is the right hydraulic lift arm. The arms that are linked by a splined shaft. I was able to order the part on Messicks and I believe it only involves removing the clip and sliding the damaged arm off and the new one on. Anyone have any experience with this?
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
whitetiger
Moderator
Staff member
Equipment
Kubota tech..BX2370, RCK60, B7100HST, RTV900 w plow, Ford 1100 FWA
There are timing marks that need alined on both the lift arm and the rock shaft when you install it.
