Removal of control knobs

[1011hans]

I need to remove the cowling under the seat/front. To do this I need to remove the plastic pressed on knobs for seat adjustment and rear implement speed. Any idea how to get them off without destroying them?
2004 B2910

 

[bird dogger]

Gently heat them up with a heat gun to soften the knob up should help. Same for putting the knob back on.

 

[85Hokie]

The word here is slowly - low heat on the heat gun and 6-8" away - otherwise the plastic will melt and deform. Patience - something I too often forget!

 

[Edke6bnl]

The word here is slowly - low heat on the heat gun and 6-8" away - otherwise the plastic will melt and deform. Patience - something I too often forget!

is there a pin holding it on.?

 

[85Hokie]

I need to remove the cowling under the seat/front. To do this I need to remove the plastic pressed on knobs for seat adjustment and rear implement speed. Any idea how to get them off without destroying them?
2004 B2910

Old thread -

B2910 Question

I have to remove a panel below the seat to access the power beyond line to replace it. The panel seems easy to remove but I'm having trouble with removing the two knobs. One is the 3pt lowering speed and the upper one is the suspension adjustment knob. I don't see any type of set screw...

www.orangetractortalks.com