Rear light relocation

[Dieselbob]

Yes folks, there are a couple of legitimate reasons I have to take my ROPS off (such as fitting the tractor on a trailer into my friends garage), but the factory setup makes it very difficult due to the light wiring, so I remove the light brackets from the ROPS and relocated them to my tool box mounting plate. Once the ROPS is off, I can bolt the tool box plate back on to keep eveything in place. This is about a three minute job with a cordless impact driver.

 

[res]

Looks good to me. Am just finishing putting the lights across my ROPS but then comes the modification to the door on the garage. With your lights being in the rear, I am pretty sure it will work just fine for you. Thanks for sharing