So, I let the battery die on my MX4800. Left key in ACC mode by accident I guess. It’s a new battery. Charged it back up and put it back in. Starts fine, but just sputters along like in limp mode for a while until it dies. Throttle does nothing. I’m gettting a P0606 and P0380 code. Replaced air filter, fuel filter, checked connections at battery terminals, checked water separator, replaced fuel pump. Bypassed tank completely. Nothing works. I’m way out in the woods with limited ability to get it on a trailer…any other troubleshooting I can do???
P0606 error code…uh oh
- Thread starter skorpion
- Start date
This may be helpful. I would stop trying to crank it and find a way to pull it out and get to dealer.
Looks like it’s a glow plug issue and a ECM issue. Good luck.
Looks like it’s a glow plug issue and a ECM issue. Good luck.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Check all fuses.
Remove the negative cable and let sit for couple minutes then reattach cable, It might reset.
If the P0606 will not reset you will need some dealer interaction to fix it.
Remove the negative cable and let sit for couple minutes then reattach cable, It might reset.
If the P0606 will not reset you will need some dealer interaction to fix it.
Appreciate it—this is a last option. Hoping to troubleshoot if possible.