Is anyone having an issue on the new L02 series with the seat switch not working properly in the cold?
Operator Presence Error
- Thread starter Conda71
- Start date
bbxlr8
Well-known member
Equipment
L2501 w/R14s, LA525, BH77, SGC0660, CL 5' BB, CL PHD, WG24 + Ford 1210 60" mmm,
Not the same model but initially mine was super sensitive over bumps on trails etc.
Drove me crazy enough to wire-tie it after I figured it out
Drove me crazy enough to wire-tie it after I figured it out
The last time I had seat switch trouble I was moving snow. Some got under the seat somehow and kept it from going all the way down. I cleared the snow under the seat and that did it. The only other time the rod under the seat on which it pivots up had come loose on one end allowing only intermittent operation of the switch. I put the rod back and replaced a washer and cotter key - problem solved.
I have a L3901DT and if I lean to far to the right, it will kill the engine. Is this the same problem you are having?
bbxlr8
Well-known member
Equipment
L2501 w/R14s, LA525, BH77, SGC0660, CL 5' BB, CL PHD, WG24 + Ford 1210 60" mmm,
Don't know about the OP regarding the cold, but that if what I was talking about. Unweighting the seat briefly "burped" the engine with power loss.
Hi All,
Thanks for the info. The L02 seats have the sensor mounted directly in the seat, I wish I had a lever that I could wiretie down. When the seat gets cold the sensor can no longer sense someone sitting in the seat.
Thanks for the info. The L02 seats have the sensor mounted directly in the seat, I wish I had a lever that I could wiretie down. When the seat gets cold the sensor can no longer sense someone sitting in the seat.
