I had a fuel hard line for a return for the injectors. Now I have installed hose return injectors due to availability! I now have an open end on the left side. What do I do with it?
Old to new B7100 HST fuel return
- Thread starter NateGreenValleyFarm
- Start date
85Hokie
Moderator
Staff member
Lifetime Member
Equipment
BX-25D ,PTB. Under Armor, '90&'92-B7100HST's, '06 BX1850 FEL
To my knowledge - there is only ONE return line to the tank. You may need to nipple that off. Rubber stopper.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Russell King
Well-known member
Lifetime Member
Equipment
L185F, Modern Ag Competitor 4’ shredder, Rhino tiller, rear dirt scoop
The FRONT injector should only have one overflow tube not two. This is an example
You may be able to get a cover and use the same clamp as the hoses. I guess you could use a hose and clamp it off or TEE it into the hose going into the tank.
You may be able to get a cover and use the same clamp as the hoses. I guess you could use a hose and clamp it off or TEE it into the hose going into the tank.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Nate,
There was not a good reason to delete this thread, the information will be of valve to someone else, if not to you.
There was not a good reason to delete this thread, the information will be of valve to someone else, if not to you.