m9960 problem

[ditchdigger2]

Hello folks , new here but I hope with all the knowledge available here y’all can help. I have an m9960 low profile tractor that I’m having a problem with, I washed the tractor a week or so ago and now it won’t start, it will turn over but the fuel pump doesn’t run, all other electronics seem to work like they are supposed too. There is a code on display it is eng ng. The book says that is engine communication problem, I’ve checked most connections in wiring harness and haven’t found anything, has anyone else ever had this happen? Thanks in advance.

 

[North Idaho Wolfman]

Go here and download the WSM, there is a very detailed wiring diagram and such.

https://www.kubota.cz/data/soubor/M8560_M9960_EN.pdf

Have you checked all the fuses, there are several that control the computer and the fuel system.

 

[ditchdigger2]

Thank you for that link, yes all the fuses are good only thing I haven’t verified are two relays that are above radiator in front of engine, the prongs were pretty corroded when I pulled them but I cleaned that up and put them back but didn’t change anything.

 

[vincentcreekfarms]

I’m having this exact problem now did you ever find the solution ?

 

[Tx Jim]

I wish you luck on getting a reply from ditchdigger2 as that member hasn't been on this site for over 7 yrs. You might be better served to open your own thread.

Another good example IMHO why threads older than a yr or 2 should be open to being viewed but blocked to new replies

 

[chim]

When i saw the code "eng ng" the first thing I thought was Engine No Good

 

[docstoy]

If working on electrical , especially computer electrical, remove negative battery connector/clamp. Look at positive cables/fuses/relays between battery and junction located at the top of radiator fan shroud. There may be corrosion or loose.