M95s won't start
- Thread starter yeboahdaniel
- Start date
coachgeo
Well-known member
Equipment
L225 w/woods Few Mowers & Back Blade, D722 in Motorcycle (Triumph Tiger), LMTV
Dead battery
bad ground
key switch fault
SAFETY SWITCH activated possible ones are seat switch, clutch not down switch, Neutral Safety switch etc.
Not familiar with that model but Safety switches are mentioned here often. either someone not familiar with tractors not using it properly or switches gone bad. Suggest you search [M95s Safety Switch] on this board. Or just Safety switch for more ideas
Last edited:
85Hokie
Moderator
Staff member
Lifetime Member
Equipment
BX-25D ,PTB. Under Armor, '90&'92-B7100HST's, '06 BX1850 FEL
At least you said "not turning over" - that is huge piece of info.
Coach Geo got the top ones.
I 'll ask a few questions.....
was it hard to turn over the LAST time it ran? if so - check battery and cables.....
Batteries can go bad - quickly, but most time they let you know they are losing it....
IF the last start was "normal" - then check all them little safety switches.....cause them little sum beaaauches will drive you crazy! As you turn the key, move a lever or two and see if anything changes................report back what you find.
Coach Geo got the top ones.
I 'll ask a few questions.....
was it hard to turn over the LAST time it ran? if so - check battery and cables.....
Batteries can go bad - quickly, but most time they let you know they are losing it....
IF the last start was "normal" - then check all them little safety switches.....cause them little sum beaaauches will drive you crazy! As you turn the key, move a lever or two and see if anything changes................report back what you find.
Does it have any power to anything or does it just simply not turn over?
My M9000 did this once and it was the battery cable ends. I shut the tractor off after using it all day and it wouldn't crank back. Cleaned the posts and ends and it was fine.
My M9000 did this once and it was the battery cable ends. I shut the tractor off after using it all day and it wouldn't crank back. Cleaned the posts and ends and it was fine.