We have a 2001 M8200. It had some debries in the fuel line from tank to water separator causing shutoff after short usage. We cleaned lines out and checked filters, etc. Lines have been bled of air per the manual's directions. It acts like it is started and acts like it runs when key switch is in the starting position, the second we release the key, it shuts off. Would air in the fuel system be causing this still?
M8200 starting issue
- Thread starter bhsm1226
- Start date
ve9aa
Well-known member
Equipment
TG1860, BX2380 -backblade, bx2830 snowblower, fel, weight box,pallet forks,etc
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Not very likely, sounds more like you have an issue with the fuel solenoid.
Check fuses as there can be several that run the solenoid.
Check fuses as there can be several that run the solenoid.
I'll check tomorrow
Thanks. Ill check it out tomorrow and see if this seems to be the issue!
