My LX2610 just died on a slope. The 5A fuse for the OPC was blown. I swapped it with the spare and it blew immediately or as soon as the key went to the first position. No lights on the instrument cluster except for the glow plug lamp when key is in that position. Engine will not turn over at all. Has anyone seen an issue similar to this?
LX2610SUHSD blowing 5A OPC fuse. Wont turn over.
- Thread starter joeswank71
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Donystoy
Active member
Lifetime Member
Equipment
LX2610HSDCC, B/H, Loader, plus numerous other attachments. B7200 sold
I would check for damaged wiring that has grounded out to the tractor around these safety switches. If you have the service manual with wiring schematics, you can check where the circuit goes using the fuse number.
I believe i found the problem. PTO switch reading 82 ohms when it should be open. I didn't have time to start tractor before dark. I have to connect everything else back and clean up the fuse boxes. was surprised at the amount of dirt on them being covered. Is this an easy swap or does the switch connect to anything in the PTO? Will update when part arrives.