Fatfenders
Member
Equipment
LX2610 HSDC, LX2980 64" Commercial Snow Blower, FEL w/60" QA bucket, BB1260 Box
Today I finally had time to install my BORA 2" wheel spacers. The fronts were easy, Since I had loaded rear tires, I thought the rears would be more difficult than they turned out to be. For the rears, I jacked up one side at a time so the tire just cleared the floor. I removed the two nuts and the four bolts and gently worked the wheel off the flange until it was free. The wheel/tire was easy to roll off to the side while the spacers were installed. Everything was torqued to spec for the spacer and the wheel once it was reinstalled.
Before I started.
Just the front done.
And the rear before.
And after.
The rears were necessary when I need to put my chains on, to provide clearance to the inner fender.
Before I started.
Just the front done.
And the rear before.
And after.
The rears were necessary when I need to put my chains on, to provide clearance to the inner fender.
Attachments
-
496.3 KB Views: 1,118