Let's see pictures of your beautiful machines

North Idaho Wolfman

North Idaho Wolfman

Moderator
Staff member
Lifetime Member

Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Jun 9, 2013
30,213
6,384
113
Sandpoint, ID
The beautiful machine of the day!



And if you think that's shocking you should see the motor! :eek:
 

Attachments

skypros

skypros

Member

Equipment
BX23s
Jul 2, 2018
67
12
8
Bend, OR
You are the 1st person I seen that has a Bolt on Cutting Edge along with the Piranha Tooth Bar (PTB)...... Would there be a problem with having both installed Bars installed (IE: wouldn't that leave about 1" of metal below the bucket).
I ask because I would like to get the PTB..... But I have the Kubota Bolt on Cutting edge..... and wonder if I should just take it off to install the PTB.

tiktock said:
I added the PTB tonight as it had already arrived and I have some digging to do right away.
Click to expand...
 
T

tiktock

New member
Jun 27, 2018
225
3
0
Plaistow
skypros said:
You are the 1st person I seen that has a Bolt on Cutting Edge along with the Piranha Tooth Bar (PTB)...... Would there be a problem with having both installed Bars installed (IE: wouldn't that leave about 1" of metal below the bucket).
I ask because I would like to get the PTB..... But I have the Kubota Bolt on Cutting edge..... and wonder if I should just take it off to install the PTB.
Click to expand...
Good question! I dont have any comparison but I havent noticed any problems with the aspect you've mentioned. I do have a slight install issue I'm working out with BX where the tabs along the bucket edge arent all contacting and we're discussing options.

In hindsight I may have considered putting the PTB on after removing the factory bar but I didnt even really think about it until you asked.

Since I use the PTB for digging, it being totally flush with the bottom of the bucket hopefully wont be an issue at all.

I'll update if any issues surface or if I change my approach. Now that I've drilled and installed, I dont think I can take the factory bar off unless I have enough play in the attachment tabs to slide it in that much further but I havent tried.
 
edritchey

edritchey

Well-known member
Lifetime Member

Equipment
A bunch of cute little Kubotas
Jul 19, 2014
1,107
806
113
Wellsville, PA
Here's a couple pics of my old L3901 it was a nice tractor just not any good for moving pallets of wood bricks so I traded it for a MX5800. I had front and rear remotes on it and a nice set of wide radial tires on the rear it did real nice mowing around our wet lands.
 

Attachments

Last edited:
You must log in or register to reply here.

Top Bottom