Need some help with my wiring.
I have an L4300D that clicks once to engage the
fuel solenoid and 3 seconds later clicks again
disengaging the solenoid.
The tractor will actually start in that interval
but won't remain running.
I can hotwire the solenoid and it will run all day.
Also I can remove the solenoid and it will run, I just have
to pull the manual kill on the injection pump like most
tractors.
My question is what powers that solenoid to the 'on' position?
I have two wires running to the thing and one seems to be the
'start' and the other the 'run'??????
Neither are ground. I have test- lighted and volt- metered this thing
to death. I have 13v when it clicks 'on' and 0v when 'off'.
If these tractors are a 'power off' design then I'm never getting the
'power on'. Bought the $80 manual but it doesn't have wiring diagram
for the electric fuel solenoid.
Any help out there??????
I have an L4300D that clicks once to engage the
fuel solenoid and 3 seconds later clicks again
disengaging the solenoid.
The tractor will actually start in that interval
but won't remain running.
I can hotwire the solenoid and it will run all day.
Also I can remove the solenoid and it will run, I just have
to pull the manual kill on the injection pump like most
tractors.
My question is what powers that solenoid to the 'on' position?
I have two wires running to the thing and one seems to be the
'start' and the other the 'run'??????
Neither are ground. I have test- lighted and volt- metered this thing
to death. I have 13v when it clicks 'on' and 0v when 'off'.
If these tractors are a 'power off' design then I'm never getting the
'power on'. Bought the $80 manual but it doesn't have wiring diagram
for the electric fuel solenoid.
Any help out there??????