1990 L2550GST DT/4Wd. The fluid was very low today in the front axle. It's done this a few times on me. I do not notice much leaking at-rest (if at all), but seems that after some solid use.. It'll be low and I will see fluid marks on the tires or down around the case.... Time to get this solved! How big of a job is this and which seals do I need?
The Questions for folks:
a) Which seals (laid out what I think below) and
b) is this a huge effort or overly complex?
Pics:
Diagram of front axle case top & bottom..
https://www.messicks.com/ku/93344?sectionId=234079&diagramId=509270
Pics or my knuckle & case: (googledrive)
https://drive.google.com/open?id=1QEKoWwsSkLu-binVspEKSfX9pZU1W4JI
also put the Kubota eng. breakdown drawing in here too.
Seals to order: For starters: I think I need the seals listed as: #60 (top) and #050 (bottom)?
The Questions for folks:
a) Which seals (laid out what I think below) and
b) is this a huge effort or overly complex?
Pics:
Diagram of front axle case top & bottom..
https://www.messicks.com/ku/93344?sectionId=234079&diagramId=509270
Pics or my knuckle & case: (googledrive)
https://drive.google.com/open?id=1QEKoWwsSkLu-binVspEKSfX9pZU1W4JI
also put the Kubota eng. breakdown drawing in here too.
Seals to order: For starters: I think I need the seals listed as: #60 (top) and #050 (bottom)?
Last edited: