L1500dt 4x4 driveshaft help

[fj55-100]

The front driveshaft on my L1500dt has taken out the splines on the yolk that has the u joints . the one that comes off the transfer case , and has made the shaft out of the transfer case in poor condition .
I havent been able to find a part number for the shaft yolk or the output shaft from the case . does anyone know where i could find these parts .
Since the l175 did not have 4x4 , I havent found any body who is familar whis this .
Thanks

 

[Ob1kubota]

As old as this Gray Market model is and no direct cross over to KAC model, if Vic can't find it, you would be better off taking your parts to a drive line fab shop and have them match up Dana Spicer yoke and U joints for your application, sincerely, Ole OB1...

 

[fj55-100]

Thanks , not many driveline shops here , but i know a few good ones in CA .
new yolk will fix it for now . with puting a pin through the hole to stop movement . but i will still need to someday find the out put stub shaft out of the transfer case .
Or else i will be real busey re welding all the splines back ,then making a cutter to remake the splines . I have a lathe ,mill ,welders ,benders , it just looked like the long/hard way .
thanks fj55-100

 

[osut362]

i have a zennoh 1500fd. its a cross between a L175dt and a L185dt. when my u-joint gave up i took the old joint to the auto supply and they measured it and they had one. $22.00 at the auto supply, $87.00 plus shipping from kubota. i told them it was an L185dt and not a zennoh....al