Ok so I topped off the trans with new fluid and the shaft leaked the fluid and turned the dry clutch into a wet clutch. I tried to use break cleaner and cleaned up the excess oil but no luck. So I split the tractor ordered a new clutch kit. New clutch, throw out and pilot bearing replaced. While I was in there I also replaced the rear main seal. BUT now it won't go forward or reverse. The pto works and ran the bush hog but no matter what I try it still won't move under the power of the clutch. Yes I adjusted the clutch but nothing changed. So maybe a shift fork issue? But I tried all of the gears and reverse. Clutch seems to work. When you push the clutch in the pto stops. Also I see the shaft moving under the fill cap. So what would make it not go??? Any ideas would be greatly appreciated. I have not retopped off the transfluid yet. I was testing it out first then I was going to clean the screen and new trans fluid.
Last edited:
