Hi All
Newbie here
I bought the above unit some time ago, but havn't used it much
I have a small bucket and slasher attachment that I run on it, all systems were go until suddenly the Implement Hydraulics would not operate..... after a short run up time without reaching operating temp
Have cleaned screens x 2 under rear axle
Where is the Hyd tank to change oil and flush using 30w Kubota Oil
Checked for air and water ingress ( all good ), pump has pressure so they tell me
Implement control Levers x 2 are working have had them checked
Where do I find the brakes to check and service them as it has very very little
Any help will be greatly appreciated
Newbie here
I bought the above unit some time ago, but havn't used it much
I have a small bucket and slasher attachment that I run on it, all systems were go until suddenly the Implement Hydraulics would not operate..... after a short run up time without reaching operating temp
Have cleaned screens x 2 under rear axle
Where is the Hyd tank to change oil and flush using 30w Kubota Oil
Checked for air and water ingress ( all good ), pump has pressure so they tell me
Implement control Levers x 2 are working have had them checked
Where do I find the brakes to check and service them as it has very very little
Any help will be greatly appreciated
Last edited:
