The throttle arm on my Kubota BX2360 just broke clean off as I was trying to throttle down.
This was adjusted shortly after purchasing new, as the throttle would not maintain a consistent rpm when operating at higher rpm levels. The local service tech tightened it up and it did not slip after that but the downside is that it was now a 2 handed operation to adjust the throttle.
It appears as though I need to remove the steering wheel in order to remove the shroud cover that conceals the point where the arm connects. Can anyone tell me how to remove the steering wheel?
This was adjusted shortly after purchasing new, as the throttle would not maintain a consistent rpm when operating at higher rpm levels. The local service tech tightened it up and it did not slip after that but the downside is that it was now a 2 handed operation to adjust the throttle.
It appears as though I need to remove the steering wheel in order to remove the shroud cover that conceals the point where the arm connects. Can anyone tell me how to remove the steering wheel?