I did d knuckle head a broke the right steering linkage on my 2501, this is the adjustable one. Have purchased a new one, know the challenge of removal on. The part that broke was nearest the center pin. I talked with mechanic and he said the end of where the threads are is tapered and is drawn in tight. To remove he said I would have to pound on real hard, but because of location it is difficult to get to. am using a long 3/4 bolt to reach from above through hole but is going no where. I have PB blaster sokeing and hoping this will help. Any other ideas?
Kubota 2501 steering linkage
- Thread starter mito352003
- Start date
Go to your local auto parts store and get a tie rod separator tool, they come in a variety of shapes and sizes
https://www.amazon.com/ABN-Ball-Joint-Pitman-5-Piece/dp/B00SX8LPZ0/
https://www.amazon.com/Universal-Ball-Joint-Separator-Shankly/dp/B01LFG1LKK
https://www.amazon.com/ABN-Ball-Joint-Pitman-5-Piece/dp/B00SX8LPZ0/
https://www.amazon.com/Universal-Ball-Joint-Separator-Shankly/dp/B01LFG1LKK
I think 100 td is telling you what you need to know, but your description, spelling and punctuation makes it somewhat difficult to follow your problem!
Yes a picture would help I will post after work today. ThanksA picture would sure allow him to get better advise!
Thanks for your help, I went to a local automotive store and purchased a pickle fork, three pounds with hammer and it was off. I knew there was a special tool to do this, probably would of broken something if I kept on. Thanks again, this forum is great.