Just wrapped up putting some lights on my LX2610 ROPS. Bought 2 small and one large LED light bar & wire harness from Amazon for about $44. An aluminum plate and couple of U-bolts allow the lights to attach to the underside of the bar. Wire harness relay is mounted to an available hole under the seat. Switch lead was long enough to make it to the dash board. Harness had two leads for lights in different directions. Cut one of these leads off and used them to extend the power leads and made it to the battery. Rear lights are great. Front light bar could be a bit more "floody" and a bit less "spotty". Did notice one thing though. The slop in the ROPS pivot pin clearance allows the ROPS, and therefore the lights, to wobble going over bumps. Will be getting a couple locking screws for the provided threaded fasteners on the ROPS.