If I were to buy a generator (450lb) can my bx2670 lift and move it?

[kickascii]

http://www.homedepot.com/p/Generac-...itch-6244/204006877?quantity=1#specifications

If so, what would the recommended method be?

 

[cerlawson]

I didn't see any lifting eyes on it. If you were to figure the bucket would lift it by lifting eyes for loading on a pick-up, the BX might not have enough lift height. 450 # would be about the same as lifting 4.5 cubic feet of earth. I think the BX would do it, but near its limit, depending on bucket model.

 

[Tooljunkie]

Most likely the cover can be removed. For service and for moving.
There needs to be some way to hoist and move/ secure them
Or they would all still be sitting in the factory.

450 isn't much of a lift even for a small loader.
Proper practice needs to be observed like on
Level ground and carry load low.

 

[kubotasam]

When I installed my Generac a few years back I moved it with my B7100. My generator had 4 holes one on each lower corner for placing the hooks from ratchet straps into. MY tractor moved mine easily. I don't see the lifting holes in the picture on the Home depot link you provided. There has got to be a recommended method of lifting.

 

[OldMasterTech]

http://www.homedepot.com/p/Generac-...itch-6244/204006877?quantity=1#specifications

If so, what would the recommended method be?

The lift holes are under the skirt around the bottom of the unit. Remove the skirt and use straps and homemade spreaders to lift. I just used forks but with a larger tractor.
You'll love the genset, I have that model and ran the whole house for 6 days during our most recent ice storm a couple years back.
Only complaint is hornets think it's a condo...

 

[Dave_eng]

If you are going to own a Generac you need to belong to the Ziller forum.
Lots of tips on hoisting and moving the units + a wealth of info on maintenance and repair.
http://www.zillerelectric.com/forums/
Dave M7040

 

[kickascii]

Thank you all for the knowledge!