Hydraulics

[OlFerguson]

Hello,

just wondering what some of you guys that work on your machines do for marking the actuator valve and or open lcs when installing a new seal kit. If this isn’t marked properly how to you determine the position in the valve bore? Thx

 

[TheOldHokie]

Hello,

just wondering what some of you guys that work on your machines do for marking the actuator valve and or open lcs when installing a new seal kit. If this isn’t marked properly how to you determine the position in the valve bore? Thx

????? What valve are we talking about? In general spools are self centering.

Dan

 

[OlFerguson]

????? What valve are we talking about? In general spools are self centering.

Dan

This is a mechanical valve made by Alo aka quickie. It’s on my Kubota. I’m from Canada , assuming that will change some machine setups. So when I put them back into the bores and put pressure to the valve , that will automatically be where I need them to be to move oil ? Hmm.

 

[TheOldHokie]

This is a mechanical valve made by Alo aka quickie. It’s on my Kubota. I’m from Canada , assuming that will change some machine setups. So when I put them back into the bores and put pressure to the valve , that will automatically be where I need them to be to move oil ? Hmm.

Not the sort of valve commonly used in NA but presumably yes. You apparently have the repair manual - what does it say?

Dan