Have l4610 with 852 loader added quick disconnects off loader valve to rear auxiliary ports.i cannot use the tilt cylinder ports only lift ports does any one have and answer the log splitter is a 2 way cylinder?
Hyd problem
- Thread starter GAZKT
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Little confused as to what you have done? 
Have you tee-ed the connections off of the valve or have you made a loop, or just have 2 lines that dead end at the rear without a valve inline?
Have you tee-ed the connections off of the valve or have you made a loop, or just have 2 lines that dead end at the rear without a valve inline?
rbargeron
Well-known member
Lifetime Member
Equipment
L5450, L48, L3250, L345 never enough attachments
It's tricky using the FEL valve to operate other things. The curl's dump circuit isn't "normal". It powers both cylinder hoses, giving better control of dump motion. I use the FEL valve for my front snowblower. The curl circuit turns the chute. It only works plumbed one way, and then only because the load is small. The difference in cylinder areas above and below the piston is enough so it moves. But it wouldn't work well for a splitter - there's not enough area difference to produce useful splitting force. Hope this helps. Dick B.
Last edited:
May want to look at doing what I did on my L3000. I used the feed line for the loader to go to another valve and then back to the loader. The new valve controls the rear remotes I added. Very simple and works perfect.
