HF Quick Hitch Dimensions

[jbolt001]

Work is slow right now so I am doodling in Solidworks on designing a box blade with hydraulic shanks. I have a HF QH on my B2401 but that is in another state so I cannot take any measurements. I need to make a mockup model to check for interference so I'm hoping someone who has one can take some measurements for me. See attached image. I need dimensions for A through I. Tape measure accuracy is good enough.

 

[Roadworthy]

If you do a bit of surfing you can find the specifications for the dimensions of the various categories of three point hitches. I don't know if that helps but there are actually standards.

 

[raptorfan85]

Work is slow right now so I am doodling in Solidworks on designing a box blade with hydraulic shanks. I have a HF QH on my B2401 but that is in another state so I cannot take any measurements. I need to make a mockup model to check for interference so I'm hoping someone who has one can take some measurements for me. See attached image. I need dimensions for A through I. Tape measure accuracy is good enough.

View attachment 50503

A-4"
B-6"
C-9 1/2"
D-8 1/2"
E-21 1/2"
F-3 1/2"
G-3 1/2"
H-1 1/4"
I-1 3/4"

 

[jbolt001]

A-4"
B-6"
C-9 1/2"
D-8 1/2"
E-21 1/2"
F-3 1/2"
G-3 1/2"
H-1 1/4"
I-1 3/4"

Thank you raptorfan85!

Dim C is too short for the leg height. Per your measurements is the leg height C + D?

 

[raptorfan85]

Thank you raptorfan85!

Dim C is too short for the leg height. Per your measurements is the leg height C + D?

Yes, the whole leg would be c+d

 

[jbolt001]

Yes, the whole leg would be c+d

Thanks, much appreciated.