HD Brush Forks

chim

Well-known member

Equipment
L4240HSTC with FEL, Ford 1210
Jan 19, 2013
2,147
1,266
113
Near Lancaster, PA, USA
Reader's Digest version. Had a set of forks made to fit pin on bucket of the L3200 that we sold, so needed another set. This time used a QA frame so they'll fit the L4240 or anything else with QA. Used 48" bale spears, a frame I picked up cheap and scraps I had stashed. Works great. Needs paint.
 

Attachments

D2Cat

Well-known member
Lifetime Member

Equipment
L305DT, B7100HST, TG1860, TG1860D, L4240
Mar 27, 2014
13,885
5,689
113
40 miles south of Kansas City
Look good. I'd suggest some expanded metal on the guard on top. Might keep your hood from scratches.

I like your grooves. Did your just do the fronts?
 

NHSleddog

Well-known member
Lifetime Member

Equipment
B2650
Dec 19, 2019
2,149
1,833
113
Southern, NH
Very nice fabrication.

x2 on the expanded metal as a guard.

It looks built "just right". By that I mean not to strong, not to weak. Just right.

People that are not material engineers tend to build in two ways; over the top strong, or way to weak. It isn't very often that you see it done "just right".

Sure you could make it a lot stronger, but the weight just keeps going up on the attachment and down on the load capacity. Make it too weak and you have a liability that won't last.

One suggestion I would make is weld on a couple D-rings. Between them and the slots you would have about any anchor need covered.

Well done.
 

chim

Well-known member

Equipment
L4240HSTC with FEL, Ford 1210
Jan 19, 2013
2,147
1,266
113
Near Lancaster, PA, USA

Attachments

RCW

Well-known member
Lifetime Member

Equipment
BX2360, FEL, MMM, BX2750D snowblower. 1953 Minneapolis Moline ZAU
Apr 28, 2013
9,249
5,436
113
Chenango County, NY
Chim - great stuff as always. Like your projects!!