Got a fuel system question

Diydave

New member

Equipment
L2202 tractor, L185f tractor
Oct 31, 2013
1,635
11
0
Gambrills, MD USA
Kubota L2202, ran it out of fuel today. There is a knurled nut on the injector pump, you can screw it in or out, tractor runs either way. I bled it, started it, finished smearing out the turds in the pasture, tried the screw both ways, does not make the least difference in how it runs.

Is this a hand prime pump, that is frozen in position? It attaches to the fuel hose from the filter and the injector rail return hose.:confused:
 

freewheel3

Active member

Equipment
MX5000DT LA852, BX1800D, B6000DT, B6200HSTD, B7100HSTD, L185, T1700HX, ZD1211
Mar 9, 2013
334
33
28
Alberta
That knob is a bleeder. It is used when you have a manual primer pump upstream of it. That engine is used in different applications that require it, your tractor might not have the manual primer pump though.
 

Bulldog

Well-known member

Equipment
M 9000 DTC, L 3000 DT
Mar 30, 2010
5,440
78
48
Rocky Face, Georgia
If it's the little round knob on the pump that is what you use to bleed the air out of the line and bring fuel to the injector pump. When you do a service or run out of fuel the knob is unscrewed, then crank the engine over. It creates a vacuum on the fuel line and pulls the fuel to the pump. After it cranks turn the knob to the right to close it. That is the correct (run) position.

My L3000 has this as well as my Bobcat mini x. I love it and wish my M9000 had the same style.
 

Diydave

New member

Equipment
L2202 tractor, L185f tractor
Oct 31, 2013
1,635
11
0
Gambrills, MD USA
Thanks for the quick replies, I think I'll just screw it in finger tight, and call it good. It was so easy to bleed, that I won't tempt providence by trying to pull upwards on it.:D
 

Bulldog

Well-known member

Equipment
M 9000 DTC, L 3000 DT
Mar 30, 2010
5,440
78
48
Rocky Face, Georgia
Thanks for the quick replies, I think I'll just screw it in finger tight, and call it good. It was so easy to bleed, that I won't tempt providence by trying to pull upwards on it.:D
It's not a pump. It works by cranking the engine over. All you do is open it and it does the bleeding for you, when it cranks close the knob.
 

Diydave

New member

Equipment
L2202 tractor, L185f tractor
Oct 31, 2013
1,635
11
0
Gambrills, MD USA
Bulldog, I was following your suggestion. I didn't think it was a pump, as it isn't long enough, nor does it have any spring behind the screw, like most pumps, at least in my experience. Hope this clears up the post, somewhat...:D
 

Bulldog

Well-known member

Equipment
M 9000 DTC, L 3000 DT
Mar 30, 2010
5,440
78
48
Rocky Face, Georgia
Diydave, I just didn't want you to be fighting with something that's there to help us out. In my experience that little knob has been a subject of great confusion.