Posted previously about a "hand-crafted" front snow plow acquired in a trade to fit my 1980 B7100. It was raised with a cable/pulley system from the 3 point hitch. Worked somewhat & could have easily been improved but I wanted to recover the use of the 3 point hitch for a rear blade. Wired up & installed (mocked up today) a 3000lb. Canadian Tire 12 volt winch ($39.95) on the front bumper. Winch is mounted on a flat plate welded to a 2"x2" tube that slides into a hitch receiver that will be welded to the bumper. Winch can easily be removed to raise the hood by pulling the hitch pin & disconnecting the quick disconnect on the electrical wires. Works slicker than "deer guts on a doorknob". Winch could also be used on the rear as I plan on fabbing up the same type hitch receiver to fit the trailer hitch. I also have a question - why does the trailer hitch pivot up instead of being fixed? Most older tractors used stay bars to prevent this when towing a trailer or wagon.