B26 being stored in a remote area without human survalance. Dealers will give out replacement keys upon request so I dont feel too safe. Any ideas of some extra security messuers ? Eg: On a old standard shift I had a chain locked to the clutch so no shifting could happen even if hot wired. Is there such a thin as a "steering wheel club" device for tractors ?
Extra Security Protection
- Thread starter jspicerreachnet
- Start date
fried1765
Well-known member
Equipment
Kubota L48 TLB, Ford 1920 FEL, Ford 8N, SCAG Liberty Z, Gravely Pro.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
With the proliferation of battery powered grinders, most locks, clubs, chains aren't a deterrent.
I don't have a B anymore but if memory serves me right I used to pull
- engine stop solenoid / fuse relay
- engine stop solenoid / fuse
- solenoid / fuse for the starter
open the bonnet and removal takes only a second or two to take with you and will mean a thief unless pretty darned smart with a lot of spare electrical parts and time on their hands is def. not going to drive it away.
remove a front tire (or take all the lug nuts) and they won't tow it away either. This takes a little longer and requires more elbow grease.
and if you drop your outriggers and frt/rear buckets and swing the boom 90 degrees into the ground almost impossible to winch/tow.
- engine stop solenoid / fuse relay
- engine stop solenoid / fuse
- solenoid / fuse for the starter
open the bonnet and removal takes only a second or two to take with you and will mean a thief unless pretty darned smart with a lot of spare electrical parts and time on their hands is def. not going to drive it away.
remove a front tire (or take all the lug nuts) and they won't tow it away either. This takes a little longer and requires more elbow grease.
and if you drop your outriggers and frt/rear buckets and swing the boom 90 degrees into the ground almost impossible to winch/tow.
Last edited:
fried1765
Well-known member
Equipment
Kubota L48 TLB, Ford 1920 FEL, Ford 8N, SCAG Liberty Z, Gravely Pro.
A "one trip" (no dents) container will likely cost $5K delivered, but it is a good storage solution.
"Cargo ready" (with dents/rust?) is less.
Friend recently bought a "one trip" 40' hi-cube container for $5K, to store his M62 TLB.
That would be easy to drag onto a trailer with a winch even with fuses puled and a club. A shed that keep it out of sight sometimes helps. You really can't trust anyone these days and cellular trail cameras can actually cach and record trespassers and notify you real-time.
Make it so it doesn't start by pulling the main fuse. Locks and chains are pointless these days, every thief has a battery powered angle grinder.
GreensvilleJay
Well-known member
Equipment
BX23-S,57 A-C D-14,58 A-C D-14, 57 A-C D-14,tiller,cults,Millcreek 25G spreader,
You , and should, ventilate a seacan. Easy to do...holes low on one side, high on the other. More holes means more flow means cooler internal temperature.
Friend found a clever way to lock his, hidden, need ladder to get on top. has one owner '62 E type in it.
Bottom line, if a thief wants it, he'll get it. Ain't no such thing as 'theft prevention' !!!
Friend found a clever way to lock his, hidden, need ladder to get on top. has one owner '62 E type in it.
Bottom line, if a thief wants it, he'll get it. Ain't no such thing as 'theft prevention' !!!
Cameras and a solar set up if no power available.
Pull the fuses as others mentioned.
Take a wheel or all the wheels with you when you go.
Pull the fuses as others mentioned.
Take a wheel or all the wheels with you when you go.
fried1765
Well-known member
Equipment
Kubota L48 TLB, Ford 1920 FEL, Ford 8N, SCAG Liberty Z, Gravely Pro.
Absolutely not true, if you ventilate them.
A container purchased for tractor storage will very likely never be used aboard ship again.
Yes…you can ventilate them…but as they are constructed and sold….they reach unbelievably high temps. We rented one to store household goods during some reconstruction in Sept thru Jan….when temps should be “ok”…. but photographs, plastic parts, Xmas ornaments, and artwork were ruined from overtemp. I suspect temps exceeded 220F in winter….might exceed 300 in summer.
If I were to buy one for serious long-term storage…I’d plan to install a window-unit AC….or at the LEAST a Turbine-ventilator with a low-wall-mounted vent.
Last edited:
PHPaul
Well-known member
Equipment
B2650, Pronovost snow blower, Landpride rotary mower, Howard tiller, box blade
Wouldn't count on cameras being of much use either, except possibly for insurance purposes.
Around here, you can show the cops all the camera evidence you want and your chances of it doing any good are approximately the same as your chances of winning the lottery.
Around here, you can show the cops all the camera evidence you want and your chances of it doing any good are approximately the same as your chances of winning the lottery.
Bmyers
Well-known member
Lifetime Member
Equipment
Grand L3560 with LA805 loader, EA 55" Wicked Grapple, SBX72 BB, LP 1272 mower
When our trailer was stolen, they cut through the lock on the gate, the lock on the trailer hitch, the lock on the tires.
Very frustrating because at best all we did was slow them down for a few minutes. I think the only thing that we could of done was remove the tires and then maybe they couldn't of taken it.
Very frustrating because at best all we did was slow them down for a few minutes. I think the only thing that we could of done was remove the tires and then maybe they couldn't of taken it.
Yotekiller
Well-known member
Equipment
Kubota L2502, LP 60" BB, LP pallet forks, 60" KK Tiller, 55" HSI root grapple
My experience is if someone wants to steal something, especially something remote like this, they will and a lock on a door won't change things. Have good theft insurance.
Runs With Scissors
Well-known member
Equipment
L2501 TLB , Grappel, Brush Hog, Box Blade, Ballast box, Forks, Tiller, PH digger
Leave the key in it as bait, and turn the PTO on.
That seems to "stump" a lot of people.
That seems to "stump" a lot of people.
This topic keeps appearing over and over.
If a thief wants your machine it'll be gone in under 5 minutes after getting dragged onto a tilt-n-load truck bed.
Out of sight and locked up in a shed/container and getting insurance will give you a little peace of mind.
If you buy security cameras you can watch grainy blurry-cam videos of your machine going bye-bye...and no CSI team will come to your rescue like on TV.
If a thief wants your machine it'll be gone in under 5 minutes after getting dragged onto a tilt-n-load truck bed.
Out of sight and locked up in a shed/container and getting insurance will give you a little peace of mind.
If you buy security cameras you can watch grainy blurry-cam videos of your machine going bye-bye...and no CSI team will come to your rescue like on TV.