BF400G loader. I didn't remove the loader so I'm not sure how it's supposed to be hooked back up. I just need to know which is "Power/pressure in," "Power Beyond," and "low pressure" back to the transmission. The two on the end are labeled "P" and "T" and the tag on the valve says BF900 with lots of Japanese. Thank you in advance!
Easy question. Loader hydraulic hookup?
- Thread starter Juztyn00
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
You have the loader valve right:
1 Pressure = from the pump
2 Tank = to the transmission case or sump
3 PB = back to the rest of the hydraulic system loop
In order to tell you the tractor end I would have to see it as there is no dedicated block like on the newer models.
1 Pressure = from the pump
2 Tank = to the transmission case or sump
3 PB = back to the rest of the hydraulic system loop
In order to tell you the tractor end I would have to see it as there is no dedicated block like on the newer models.
Thank you, Yes I have the correct diverter block for my tractor, just didn't want to put the hoses in the wrong places. Much appreciated!
Now that you have it figgered out, a simple trick, is to take 6 colored wire ties, (2 of each color), and put one on each side of each connector...
And/or borrow some colored nail polish and put dots on the fittings. Between wife and 2 daughters, i have every almost every color possible