Cut height for brush cutter

[Flat6s]

My pto shaft problem is now resolved. So my next issue is :
Is there a way to set the cut height for the 3 point hitch to lower to and stop. So what I mean is...I lower the three point hiitch and it does not stop. I have to guess how low it is each time,
Just does not seem right. The MMM has a cutting height knob, seems like the three point lowering lever should have one also .
Thank you
Joe

 

[North Idaho Wolfman]

There is no way to set a three point for height on that model.
You would accomplish that with check chains set to the height that you want.

 

[85Hokie]

My pto shaft problem is now resolved. So my next issue is :
Is there a way to set the cut height for the 3 point hitch to lower to and stop. So what I mean is...I lower the three point hiitch and it does not stop. I have to guess how low it is each time,
Just does not seem right. The MMM has a cutting height knob, seems like the three point lowering lever should have one also .
Thank you
Joe

There is no knob obviously - but there are simple ways to set a "stop" and have it adjustable too!

Called a limiter chain - cheap and very effective.

type in limiter chains in google - you'll see a couple of ways to set your cutter to a set height and have the adjust ability to raise and lower it as you wish.

here is a pdf :

http://www.ntractorclub.com/howtos/pdfs/Limiter-Chains.pdf

 

[In Utopia]

Here ya go.
Been using this setup for years.

 

[SDT]

My pto shaft problem is now resolved. So my next issue is :
Is there a way to set the cut height for the 3 point hitch to lower to and stop. So what I mean is...I lower the three point hiitch and it does not stop. I have to guess how low it is each time,
Just does not seem right. The MMM has a cutting height knob, seems like the three point lowering lever should have one also .
Thank you
Joe

Like Wolfman says, without position control, you will need limiter chains.

SDT

 

[jpf]

limiter chains, same as I used for years with the ford 2n.