I have 3 Kubotas. A BX 1870, a BX 2380, and a BX 25. While using the equipment I carry a 32 ounce mug of ice water. The mug fits perfectly in the cup holder on the 1870 and the 25 but will not go to the bottom of the holder on the 2380. It tends to bounce out on rough terrain. Short of cutting the bottom out of the built in cup holder on the 2380, is there any suggestions on how to get the mug to fit?
Cup holder on BX 2380
- Thread starter ralphpete
- Start date
Maybe this---or use a smaller cup.
www.weathertech.com
Car Cup Holders: CupCoffee | WeatherTech
The WeatherTech CupCoffee cup holder expander was created for users of 14, 20 or 24 oz. YETI™ Ramblers, to easily adapt it to their vehicle’s cup holder.
www.weathertech.com
Thanks. Looked it up. May not fit my 32 ounce mug. Also looks like it would position my mug quite high which means I would always be hitting it with my elbow or arm . Anyone think I can reform the original holder with a heat gun?Maybe this---or use a smaller cup.
Car Cup Holders: CupCoffee | WeatherTech
The WeatherTech CupCoffee cup holder expander was created for users of 14, 20 or 24 oz. YETI™ Ramblers, to easily adapt it to their vehicle’s cup holder.