L2800 hst cranks over but won't start .changed lift pump ,fuel fliter,fresh gas, figured electrical but don't know where all safety switches are? Any ideas?
Crank no start
- Thread starter combs580
- Start date
85Hokie
Moderator
Staff member
Lifetime Member
Equipment
BX-25D ,PTB. Under Armor, '90&'92-B7100HST's, '06 BX1850 FEL
Lol my bad ,yes I put diesel in it. All it has is the vent screw to get the air out of lines. I followed the procedure in the manual. no worky
85Hokie
Moderator
Staff member
Lifetime Member
Equipment
BX-25D ,PTB. Under Armor, '90&'92-B7100HST's, '06 BX1850 FEL
Sometimes you need to bleed the system longer that you might think - sometimes the air bleeds quickly other times it take several key sessions. Try again and again - it should fire after a few more.
I agree with @85Hokie , I would keep trying to bleed air.
I'm not claiming to be an expert in bleeding diesels, but my method that works for me is:
1. Pull decompression if applicable
2. Do not engage starter for more than 30 seconds, then cool for 2 minutes.
3. Pre-fill fuel filter
4. Open port/ vent on top of filter housing
5. Crank, wait till fuel, then close
6. Crack open main line into injection pump from filter
7. Crank, wait for fuel, tighten
8. Loosen lines at the injectors.
9. Crank, wait for fuel, close one by one.
10. Disengage decompression valve if applicable.
Hope this helps.
I'm not claiming to be an expert in bleeding diesels, but my method that works for me is:
1. Pull decompression if applicable
2. Do not engage starter for more than 30 seconds, then cool for 2 minutes.
3. Pre-fill fuel filter
4. Open port/ vent on top of filter housing
5. Crank, wait till fuel, then close
6. Crack open main line into injection pump from filter
7. Crank, wait for fuel, tighten
8. Loosen lines at the injectors.
9. Crank, wait for fuel, close one by one.
10. Disengage decompression valve if applicable.
Hope this helps.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Did it run out of fuel?
Did it run recently?
Sounds like you more than likely have a problem with the stop solenoid (in this case it's a run solenoid).
If it's not working you won't get it to start.
Test it like the WSM states.
Look at the Envelope top right of your screen.
Did it run recently?
Sounds like you more than likely have a problem with the stop solenoid (in this case it's a run solenoid).
If it's not working you won't get it to start.
Test it like the WSM states.
Look at the Envelope top right of your screen.