I am looking at a JD8 BH with sub frame, wondering if it could be fit to a L3010? The 3010 does not have hydraulics at the rear PTO. Thanks
Can a JD8 BH fit L3010
- Thread starter DigVT
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Several things come into play:
Is the JD BH you are getting equiped with an open center valve or a closed center valve? It must be an open center valve, a closed center valve will not work.
Your going to take some work to alter the BH bracket to fit your Kubota.
And yes you will have to add a PB loop to the tractor to run the BH.
Is the JD BH you are getting equiped with an open center valve or a closed center valve? It must be an open center valve, a closed center valve will not work.
Your going to take some work to alter the BH bracket to fit your Kubota.
And yes you will have to add a PB loop to the tractor to run the BH.
A JD8 is open Center. I was able to mount it on my L235 using the JD subframe.
I got a B3300 and instead of modifying it, I purchase a kubota subframe and modified the back how to have a 4pt mount like the newer ones. I'm planning a Thread on the entire build, but got stalled with making hardlines for the top n tilt and powerbeyond I am adding for the backhoe.
If you are handy, you should have no issue on your L3010
Sent from my STV100-3 using Tapatalk
I got a B3300 and instead of modifying it, I purchase a kubota subframe and modified the back how to have a 4pt mount like the newer ones. I'm planning a Thread on the entire build, but got stalled with making hardlines for the top n tilt and powerbeyond I am adding for the backhoe.
If you are handy, you should have no issue on your L3010
Sent from my STV100-3 using Tapatalk
How difficult, and expensive is it to bring hydraulics to the back PTO area, is that just 2 hose connections? Was the modification of the JD sub frame to the L235 a major project?
Thanks
Thanks