BXpanded Ripper Tooth

[N3BP]

Need your help fellows. I want a BXpanded ripper tooth for my Woods BH7500 backhoe that's on my L2900. They only make them for Kubota backhoes. I emailed them and they said they don't make anything to fit my 7500. I suspect I could modify one to fit my backhoe. If anyone has a BH65, BH70, BH75, BH76, BH77, BL4690B, BT750, or BT751, could you please measure your pin spacing for me? I'd really appreciate it. The inside distance between ears on the BH7500 is 4.25'', and the hole distance between a single ear is 7''. It takes 1'' pins and I know the Kubota buckets use 25mm pins which is pretty much the same. Thanks for your help!

 

[Henro]

I have a B4690A Kubota backhoe.

Looks like the spacing of the pins is 6.5 inches, and the width between the inside of the tabs where the stick end goes is about 3 and 7/8 inches.

I went down and measured but forgot a pencil...AND you did not ask about the BL4690A anyway...but it is likely the same as the BL4690B I would think. The pins are 25mm..

If you need a more exact measurement let me know. Maybe someone else here can do better...

 

[Nicfin36]

On my BH77, it looks like 6 1/2" in contrast to your 7, and 3 14/16" in contrast to your 4.25".

 

[Nicfin36]

Henro beat me to it, but both our measurements are definitely the same.

 

[Henro]

Henro beat me to it, but both our measurements are definitely the same.

Good job man! ROFL

Forgetting my pencil, I am surprised I remembered correctly...

 

[Mjinpa]

BH70 - 6 1/2 x 3 7/8

 

[N3BP]

Thank You everyone for your replies. They are much appreciated. The 6 1/2 wouldn't be too much of an issue, but the 3 7/8 is more problematic. It still may be modified to squeeze it in. Thanks Again!