BX2660 leak

[wooneye]

O.K., I checked the other forums & found nothing, so I please need some opinions: I have an '08 BX2660 (220 hrs.) and just put a 2750C snowblower on it. Used it for about 6 hrs. Everything works fine, BUT, there is now a seal failure/leak (not bad, but irritating) at the mid-pto shaft. Causes? Solutions?
Thank You.
Bob

 

[pat331]

I'm not familiar with your setup and know very little about snowblowers, but your problem could be a gearcase that is overfilled. I had that happen to me on a bushhog. I overfilled the gearcase and it started leaking after several hours of use. Good Luck!

 

[wooneye]

Thanx Pat, I think that done it. I purchased the Kubota 3 months ago & the guy told me he just serviced everything so I did not check it too close. Yes, the tranny fluid was way above the "full" mark. Drained some & it seems to have done it. Thanx again