Hi, I just recently picked up a pretty clean BX 25 I believe it is a 2015. The previous owner did put new tires on and I noticed all of the rims were on the wrong way ( Spun around ) I got that corrected but I noticed one of the rear rims has 2 holes that are egged out and the other three appear fine. I remounted everything and torqued them to spec. What are your guys thoughts on this? The rims look new besides this issue.
BX25 Question about rear rim and slighly egged mounting holes.
- Thread starter Joe.G
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
A picture of how bad they are might help, You could use a washer to allow it to hit all sides and stay tight.
Yeah I figured that, I'll take it off when i get a chance. I think if I just keep an eye on it'll be okay, This machine isn't doing any big jobs.
I did add a washer to each, I used a softer washer that bent into the hole a little.
I did add a washer to each, I used a softer washer that bent into the hole a little.
