I just purchased a new to me front mount snow blower for my Bx25d. I’m just starting to go through it and was wondering a few things. Anything specific I should check out for wear and possible replacement before I run it and biggest of all in my book. The two hydraulic hoses do not have a color coded end, I’m not sure what connection to plug them into? Does anyone have any pics of their unit installed where I can see where the top and bottom of the cylinder hoses plug into ? Any leads on a .pdf manual are also appreciated. Thank you.
BX 2751 and BX2750D snow blower
- Thread starter Mariner
- Start date
If I remember right the front lift uses the yellow and white ports on your loader valve. Plug one into each, then try it. It should lift when the joystick is pulled back and it should move down when the joystick is pushed forward. If it operates opposite of that, just swap the hoses. Then label them for future use.