A 12 volt HF fuel transfer pump and I think a 15 or 20 gallon drum off market place, it makes it easy to move with the HF dolly, was all under 100 bucks. You could go for a 55 gal drum mount it on a drum catty and still be under 100 bucks I would think. Im not sure what the flow rate is , but you dont want to get distracted. I went with the small drum that way there is always fresh or pretty fresh fuel and at least in my mind was a good idea.
Building a fueling station.
- Thread starter William1
- Start date
I got the parts. First length of fuel hose to use as a joint was too large (1-1/2" ID Opps!) Got a length of 1-1/4" ID, tight in the nipple almost as tight on the fuel rig tank. Should be good.
Had a 4" nipple, chopped the threads off one end, a little filing. Cut the hose to length. Four Banjo clamps, one will be up high on the nipple, one will be where the nipple and tank pipe meet to stiffen that further, a third\ right below and one done low. Should be plenty rigid and secure.
I'll be running a ground bond wire from the pump the rig. Then a second ground wire to a clamp. Extra safe.
Had a 4" nipple, chopped the threads off one end, a little filing. Cut the hose to length. Four Banjo clamps, one will be up high on the nipple, one will be where the nipple and tank pipe meet to stiffen that further, a third\ right below and one done low. Should be plenty rigid and secure.
I'll be running a ground bond wire from the pump the rig. Then a second ground wire to a clamp. Extra safe.
Have the bottom adapter for the Fill-Rite pump on the nipple. Used a little PTFE tape (cue the complaints) then my pipe wrench with a layer of rubber (to prevent marring the nipple). Cranked down plenty tight.
A film of oil on the inside of the rubber hose, got the rubber hose on the nipple with a little force. Banjo clamps I have are just a tad small, ordered the next size up.
A film of oil on the inside of the rubber hose, got the rubber hose on the nipple with a little force. Banjo clamps I have are just a tad small, ordered the next size up.
I was thinking..... the Banjo clamp I'm going to put on there the two pipes meet in the center to stiffen, is there such a thing as a double wide Double Banjo clamp? Something like 3" wide with two clamp bolts? I could of sworn I've seen them but cannot recall what they are called.
Like this but a Banjo?
Like this but a Banjo?
