Please help me out here guys, I have a Kubota 2710 and the bucket works at a slow rate and is jumpy. I changed hydraulic fluid and the same results. I warm it up and its a little better but still not up to performance the back pto works great just the front loader that don't seem to be working as quick as it use too.
Bucket working slow
- Thread starter stapleton32
- Start date
Does the position of the 3 point hitch effect it? Does it work faster if the 3 point is in the lowest position?
I've got a similar problem.
Two items recommended to me:
check - quick-connect hydraulic connectors (at dentent/control valve) as they may be dirty,
and seals in pistons may need replacing (this is more related to poor lift/down pressure).
Two items recommended to me:
check - quick-connect hydraulic connectors (at dentent/control valve) as they may be dirty,
and seals in pistons may need replacing (this is more related to poor lift/down pressure).
Can you hear unusual hydraulic whine? If so, you may have to reset the limit on your 3 point hitch lift lever. If it goes up to far, it will deadhead the hydraulics and cause the rest of the hydraulic system to act peculiar. Just lower the lever until the whine stops.
First thing I thought is air in the system.
Does the hyd fluid look milky like it's full of air bubbles?
You could have a split in the rubber boot on the suction line.
Does the hyd fluid look milky like it's full of air bubbles?
You could have a split in the rubber boot on the suction line.