on my newly acquired B6000, when I put on the backhoe hydraulic pump on the rear PTO, it vibrates a lot. I found out the PTO shaft is bent by ~1-2mm at the tail end.
I am toying the idea of using a PTO adapter and some large metal pipe to bend it back with it right on the tractor. Will the transmission handle this? Considering that the previous owner has it bent somehow without damaging anything (?) is it a possible option?
Has anybody done similar thing?
If I take it off, I cannot easily find an anchor point to hold it for that kind of force.
I am toying the idea of using a PTO adapter and some large metal pipe to bend it back with it right on the tractor. Will the transmission handle this? Considering that the previous owner has it bent somehow without damaging anything (?) is it a possible option?
Has anybody done similar thing?
If I take it off, I cannot easily find an anchor point to hold it for that kind of force.
Last edited: