Bell Tec Auger on L4400

[Redrattler]

I have a Kubota L4400 and looking to have to build some fence. Problem I have is it is quite rocky so looking into a Bell Tec TM 48. Anyone used one on a L4400 and how hard to install a rear aux remote? I haven't had much luck finding anything on the internet from others who went this route.

Thanks for any help!!

 

[mickeyd]

Welcome to the forum from Alabama. I have never used one them before so I can't help you.

 

[North Idaho Wolfman]

No first hand use of that auger but reading the specs and reviews it's a really nice setup!

Note: It requires 2 remotes to run it.
The remotes are easy enough to install they are basically just bolt on parts.

 

[RIDETOEAT]

I have a L4600 and just 2 weeks ago had my dealer quote me $1300 for dual factory remotes installed, levers would come up through the factory slots. In the case of an auger operation like yours I am not sure I would not rather have a different location for the rear remote control levers since I cannot access mine if not sitting on the tractor and can't see well behind me sitting on it.

 

[North Idaho Wolfman]

In the case of an auger operation like yours I am not sure I would not rather have a different location for the rear remote control levers since I cannot access mine if not sitting on the tractor and can't see well behind me sitting on it.

This is the kind of auger that you always want to be in the seat to run!

 

[Redrattler]

It can't be too hard to install the remotes myself.... Wonder how much that would save me?

 

[Redrattler]

Glad i found this site. Didn't know it was out here. Lots of useful info!

I have a lot of rock to drill and was told belltec way to go.....

Any other implements yall would recommend instead??