Doing a complete service on the deck of the T1460. Using a steering wheel puller, I got the 2 sheave drive assembly off the shaft, and the gear puller got the bearings out of the blade spindle housings and the deck shaft.
My question is how does everyone get them back together? It appears that a press is the correct way, but I don't have one. The fit is too tight to squarely get them in any other way. Short of going to the dealer, I'm looking for some other creative ideas that may not involve a press.
My question is how does everyone get them back together? It appears that a press is the correct way, but I don't have one. The fit is too tight to squarely get them in any other way. Short of going to the dealer, I'm looking for some other creative ideas that may not involve a press.