Need help with replacing hour meter/tach on B8200. Do you need to remove the fuel tank to get behind the dash to replace unit? Thanks in advance for replies.
B8200 replace tach/hour meter
- Thread starter smullen17
- Start date
You don't have to take off the fuel tank to change it. Loosen the dash, slide it up the steering shaft to access the two nuts on the tach clamp and unscrew the cable. The dash is held in place by four 12mm bolts.
Dion, Thanks, It worked great lifting up the dash. I can certainly get in to fix. Would you know where the flasher is located? My flashers are not working and I see a flasher unit on the electrical diagram. A little background...I just bought the B8200 in Early Jan. 1100hrs. 2wd gear. $3K I am going to use to cut 3 acres. I was using an 8n with 3pt finish mower, too much turning. Needed a belly mower. What a great unit. I now see why everyone loves these Kubota's! Thanks again Steve
You were right there, If I remember correctly it's actually on the underside of the dash right beside the tach. A black rectangle box 1" by 1" by 2" and held in place by one bolt. Sounds like a good deal and am glad your happy.