My B7200 kabota, runs in low speed, but put in high speed, looses power and kills the engine, even going up a slight incline. Is this a hydraulic, pump failure? I've looked at pumps on line, it says easy install, then says professional install recommended. Is this my possible problem and is install that difficult? Thanks for anyone's input.
B7200 loosing power, runs in low speed, high speed looses power
- Thread starter Carebear
- Start date
Check your fuel filters .under load if clogged it will starve engine .for fuel causing shut down
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
No it's not a Hydraulic Pump failure.
Could be an HST failure, but that's not very likely.
Does the engine bog down?
If it does bog down, does it smoke?
When was the last time you did fluids and filters?
Have you checked the fuel filter and the air filter?
When was the last time it was refueled?
Smell the fuel does it smell like gasoline?
Could be an HST failure, but that's not very likely.
Does the engine bog down?
If it does bog down, does it smoke?
When was the last time you did fluids and filters?
Have you checked the fuel filter and the air filter?
When was the last time it was refueled?
Smell the fuel does it smell like gasoline?
Thats an old machine and may just be getting tired. I had a DT and it still struggled with grades in high range.
Dan