I had my 3 point hitch repaired at my local Kubota dealer. Everything was originally working at the time I removed the control I have change all the oil and cleaned all filters. The reason for the repair was leaks on the control arms that exit the body. New o rings where installed and the leaver is much more stable.
After installing the control back in, I ran the tractor for two minutes and rechecked my oil level. Topped up the oil and checked again. The oil level is up to the top mark on the dip stick.
\
My problem is the 3 point will not lift and I am curious about an air lock. I noticed on the top of the control is item 300 of the parts breakdown. a pipe plug looks like a 1/8 pipe in size ( I assume metric ). Is this Plug used to blead off air, and if so is there a procedure to blead off the air?
P.S. the Hydraulic steering is working and the tractor is operable.
Any help would be much appreciated.
After installing the control back in, I ran the tractor for two minutes and rechecked my oil level. Topped up the oil and checked again. The oil level is up to the top mark on the dip stick.
\
My problem is the 3 point will not lift and I am curious about an air lock. I noticed on the top of the control is item 300 of the parts breakdown. a pipe plug looks like a 1/8 pipe in size ( I assume metric ). Is this Plug used to blead off air, and if so is there a procedure to blead off the air?
P.S. the Hydraulic steering is working and the tractor is operable.
Any help would be much appreciated.