b4200 diverter valve issue

[North Idaho Wolfman]

That port is only active when the three point control is used.
It's not a good port to tie in a loader!
You need to add a block to the hydraulics and tap for the loader from it.

B7100 Hydraulic block diverter (70060-00360 or 70070-00385)

Back in stock. CDN$40 plus actual shipping These are obsolete and no longer available. I have recently been contacted by a member asking if I will make him one of these after reading how I made mine. I know this comes up from time to time and would like to gauge the interest others might have...

www.orangetractortalks.com

 

[jmielnicki]

I dont think that is a diverter. Its a tap into the lift cylinder. If so you only get flow with the 3pt lever locked in the full up position.

Dan

I just tried that and still nothing

 

[TheOldHokie]

I just tried that and still nothing

Exactly what did you try? Does your valve have 3 positions - left, right, and middle?

Post a picture of the 3pt lever guide

Dan

 

[jmielnicki]

Exactly what did you try? Does your valve have 3 positions - left, right, and middle?

Post a picture of the 3pt lever guide

Dan

Just left and right

 

[jmielnicki]

Just left and right

3 point lever

 

[jmielnicki]

3 point lever

I put 3 point all
The way up and switched backed to bucket

 

[TheOldHokie]

I put 3 point all
The way up and switched backed to bucket

Here are instructions for using the valve. I thinl they are a bit misleading. The 3pt lever has to be held in the rear position to keep flow going. If the 3pt lever returns to neutral flow stops.

 

[jmielnicki]

Thank you again Ill see what I can figure out

 

[Russell King]

@jmielnicki

Did you just get this tractor or have you had it awhile and it’s operation of the FEL changed suddenly and recently?

 

[jmielnicki]

I got it over the summer from a family member that never really maintanded it. evrerything was working when I brought it home all I did was change oil and coolant then bucket stopped working and pulled suction tube filter out and it had 1/4" sludge all around it then changed hydraulic fluid and still not working thats why I thing there is still sludge blocking flow. Just trying to get it backl all operational so I can use it around the yard

 

[jmielnicki]

The instructions you sent describes the issue I am having that oil doesnt flow to the implemt when turned that way

 

[TheOldHokie]

The instructions you sent describes the issue I am having that oil doesnt flow to the implemt when turned that way

What in those instructions describes your issue? You can take the valve off if you want. It is just a ball valve in the cylinder cap. But before you do that I suggest you check the pin in the handle - part number 70 in this drawing.

Dan

 

[jmielnicki]

ok
What am I looking for when inspecting the pin

 

[jmielnicki]

I was refering to the valve in the instructions that is my issue

 

[TheOldHokie]

ok
What am I looking for when inspecting the pin

That it is intact and the valve stem is turning the full 180 degrees.

We understand you are not getting flow from the valve. I can only think of two reasons for that:

1. The handle is not turning the valve.
2. You are not holding the 3pt lever in the raise position

Since that valve stem also feeds the 3pt and the 3pt is working I dont think there is much chance it is clogged.

Dan