b4200 diverter valve issue

[North Idaho Wolfman]

That port is only active when the three point control is used.
It's not a good port to tie in a loader!
You need to add a block to the hydraulics and tap for the loader from it.

B7100 Hydraulic block diverter (70060-00360 or 70070-00385)

Back in stock. CDN$40 plus actual shipping These are obsolete and no longer available. I have recently been contacted by a member asking if I will make him one of these after reading how I made mine. I know this comes up from time to time and would like to gauge the interest others might have...

www.orangetractortalks.com

 

[jmielnicki]

I dont think that is a diverter. Its a tap into the lift cylinder. If so you only get flow with the 3pt lever locked in the full up position.

Dan

I just tried that and still nothing

 

[TheOldHokie]

I just tried that and still nothing

Exactly what did you try? Does your valve have 3 positions - left, right, and middle?

Post a picture of the 3pt lever guide

Dan

 

[jmielnicki]

Exactly what did you try? Does your valve have 3 positions - left, right, and middle?

Post a picture of the 3pt lever guide

Dan

Just left and right

 

[jmielnicki]

Just left and right

3 point lever

 

[jmielnicki]

3 point lever

I put 3 point all
The way up and switched backed to bucket

 

[TheOldHokie]

I put 3 point all
The way up and switched backed to bucket

Here are instructions for using the valve. I thinl they are a bit misleading. The 3pt lever has to be held in the rear position to keep flow going. If the 3pt lever returns to neutral flow stops.

 

[jmielnicki]

Thank you again Ill see what I can figure out

 

[Russell King]

@jmielnicki

Did you just get this tractor or have you had it awhile and it’s operation of the FEL changed suddenly and recently?

 

[jmielnicki]

I got it over the summer from a family member that never really maintanded it. evrerything was working when I brought it home all I did was change oil and coolant then bucket stopped working and pulled suction tube filter out and it had 1/4" sludge all around it then changed hydraulic fluid and still not working thats why I thing there is still sludge blocking flow. Just trying to get it backl all operational so I can use it around the yard

 

[jmielnicki]

The instructions you sent describes the issue I am having that oil doesnt flow to the implemt when turned that way