B2650

[hdhedges]

Book says not to exceed 48 inch rotary cutter[500] lbs. Any body running bigger than 48 inch? If so what are your results?

 

[Deuce]

I hAve a 72" woods prd rfm, weighs 718 lbs per factory. Machine runs it and lifts it no problem, I think it's more an issue of ballast but my fel evens it out. I'm pretty sure that spec is for max rear load without any counterweight on the front to keep the front end from getting too light with the rear attachment in the air

 

[MadMax31]

A rotary cutter eats HP faster than a RFM. Typically its 5hp per foot. So you should have 25 PTO hp to run one. Can it run one? Sure. Just not at rated sapling thickness and much slower ground speed.

Ive read where Kubota will void a warranty on an implement not listed. Might want to investigate that rumor?

 

[OrangeLivin]

Yes there's a fairly recent thread about Kubota denying warranty coverage on a new tractor due to using an implement that's not on the list.

Here it is:

http://www.orangetractortalks.com/forums/showthread.php?t=25410&highlight=warranty

IMO, if the tractor is new and still under warranty, 'if in doubt, leave it out'.