Ok. I'll give it a shot. However, I'm wondering how to physically connect at least 2 sets of wiring harnesses to the one factory OEM plug. It has (2) 1/4" spade connections, one turned perpendicular to the other, sitting inside a green plastic casing. Should I just remove that plastic green piece, or is there a part available somewhere that I can connect my LED wires to, and then just plug that into the OEM green piece?
Next piece of the puzzle...
After complaining to the LED cube light supplier that they sent me a wiring harness meant for one light bar (but they sent it with 2 LED cubes), ie it only has one set of leads, not 2 leads to connect both lights, they said they'd send me more wiring. Just received it and it is the exact same 1 lead wiring harness. So since I had bought 2 sets of these 2 LED cubes (one set for front facing and the other set for rear facing) I now have 4 sets of wiring harnesses (complete with relay, fuse, switch). Trying to figure out best way to cut a long length of wire from one harness and connect it to another harness to turn it into a 2 lead harness.
Next piece of the puzzle...
After complaining to the LED cube light supplier that they sent me a wiring harness meant for one light bar (but they sent it with 2 LED cubes), ie it only has one set of leads, not 2 leads to connect both lights, they said they'd send me more wiring. Just received it and it is the exact same 1 lead wiring harness. So since I had bought 2 sets of these 2 LED cubes (one set for front facing and the other set for rear facing) I now have 4 sets of wiring harnesses (complete with relay, fuse, switch). Trying to figure out best way to cut a long length of wire from one harness and connect it to another harness to turn it into a 2 lead harness.
