I checked the pressure off one of the FEL connectors and it was 1800 PSI at 2500 RPM. That seems kind of low. Anyone know what the pressure is supposed to be and how to adjust it?
Adjusting hydraulic pressure on L3901
- Thread starter afret
- Start date
According to the Kubota specs page: http://www.kubota.com/product/L3301/L3301.aspx
The system pressure is 165 kgf/cm2 which converts to 2346 PSI (why can't they just say that!
)
I can't help on the adjustment, but if it's under warranty I'd be calling the dealer. If you going to do your own wrenching, then the factory tech/service manual would be a great investment.
The system pressure is 165 kgf/cm2 which converts to 2346 PSI (why can't they just say that!
)I can't help on the adjustment, but if it's under warranty I'd be calling the dealer. If you going to do your own wrenching, then the factory tech/service manual would be a great investment.
Thanks again for sending the pressure gauge so quickly. It's a very nice instrument and super easy to use.
I called the Kubota dealer service guy and he had me redo the test at full throttle and it was still only 1900 PSI. He will order some shims and come by to install them.
I called the Kubota dealer service guy and he had me redo the test at full throttle and it was still only 1900 PSI. He will order some shims and come by to install them.
Good news, good dealer.
Many Kubota's seem to get shipped with low pressure for some reason, been that way for many years unfortunately.
Oh and your welcome, my pleasure
Many Kubota's seem to get shipped with low pressure for some reason, been that way for many years unfortunately.
Oh and your welcome, my pleasure
What was the pressure at the 3 point hitch, which is where the tractor is supposed to be checked per the WSM?